bullseye reloading data - An Overview

bullseye reloading data - An Overview

Blog Article

As for all other powders, both have a challenge with them not with the ability to continue to be beneath Functioning pressures at about 1300fps because they have a quicker melt away rate that St marks 296, or burn off so warm that They simply burn off up the hulls rapidly isntead.



Have confidence in is, the AA CF hulls have considerably less quantity when compared to the HS hulls, and it not really a Doing the job tension problem, but just not sufficient place in the hell to get it up more than 1300fps Using the necessary volume of powder as a substitute.

Concerning migrating 296, I utilize the Spolar furnished rubber gromet below an just after current market pyrodex powder tube from SGW member skeeljc and there is hardly any powder migration with my #405 Spolar.

All there powders can get you to 1350fps in 410 no problems (without even finding close to max Doing the job pressures), and due to the fact They may be both of those really near to precisely the same melt away array of powders, it all arrives down which one you'll find the the very least high priced as an alternative.

LilGun burns up my hulls too quick as does Alliant 410. I've also attempted almost all the things else. Do not remember my gripes with the Other individuals, but I have been making use of H110 a long time and always are actually pleased with it.

The remainder of the powders for 410 loads, Possess a burn up speed of close to 295, and just end up burning up the hulls swiftly to begin with, and will never be capable of achieve the 1350fps prior to the ammo goes around tension.




Now let me acquire it action farther since you are coming out of H110/296 and going into 410 powder. You are likely to burn off up hulls at a much faster price, and could not even such as 410 loads when It truly is all claimed and finished (inconsistency).

all powder will burn up up hulls but with these a few I may get 6 to ten reloads without a problem. Dependant upon the hull choice There is certainly enough tested load data on This great site redirected here for these powders. Just look for it out you will not be dissatisfied.

Powder would seem a tiny bit soiled and perhaps burns up the hulls a tad more rapidly, I think (however easily get 5 reloads without having an excessive amount shut inspection and sorting-some very last extended but will need shut look following a couple reloads). I’m conservative over the reloads and dispose before than numerous do I feel. Crimps are pleasant in ninety nine% in the hulls even through many reloads. Total I like it plenty of to maintain applying it.

0   Reply This can be an older thread, you may not get a reaction, and could be reviving an outdated thread. Please look at making a new thread.

This really is an older thread, you may not receive a response, and will be reviving an old thread. You should think about creating a new thread.

Now let me consider it step farther because you are coming out of H110/296 and heading into 410 powder. You will burn up hulls at a much faster level, and should not even such as the 410 loads when It is all claimed and accomplished (inconsistency).




Conclusion: Accurate 1680 Powder is usually a high-functionality choice for tiny caliber rifles and discover this pistols, offering reliable overall performance and accuracy for discerning marksmen.

We emphasize on the standard of our espresso as on our good quality of provider, delivering our clientele with overall versatility to go over their wants always.